Before You Begin; Battery Installation And Removal; Battery Charging - Yaesu FTA-750 Operating Manual

Battery Installation and Removal

 To install the battery, insert the battery pack into the
battery compartment on the back of the radio, press
the end of the battery pack while pressing the bat-
tery pack latch on the bottom of the radio, then lock
the pack by sliding the locking plate beside the latch
until the entire "LOCK" appears.
 To remove the battery, turn the radio off, slide the
locking plate until the "UNLOCK" appears entirely,
lift up the end of the battery pack while pressing the
battery pack latch, then pull out the battery from the
radio.
Do not attempt to open any of the recharge-
able Lithium-ion packs, as personal injury
or damage to the Lithium-ion pack could
occur if a cell or cells become accidentally short-
circuited.
FTA-750/FTA-550 O
B
eFore
Battery Pack
Latch
S H
P U
M
perATing AnuAl
y B
ou egIn

Battery Charging

It is necessary to charge the Lithium-ion battery fully
before its first use. Follow the procedures below:
1. Install the supplied Lithium-ion battery pack onto the
transceiver. Ensure that the transceiver is switched
off.
2. Insert the cable plug of the SAD-11 Battery Char-
ger into the jack located on the back of the SBH-11
Charging Cradle, then plug the SAD-11 into the AC
line outlet.
T A
D A
T
E X
D C
SBH-11
3. Insert the transceiver into the SBH-11; the antenna
jack should be at the left side when viewing the
cradle from the front.
FCC ID: K6650013X20
IC: 511B-50013X20
SAD-11
11
YAESU MUSEN CO., LTD.