Fluke 9133 User Manual page 36

9133
User's Guide
Table 2 Controller Communications Commands
Command Description
Display Temperature
Read current set-point
Set current set-point to n
Read temperature
Read temperature units
Set temperature units:
Set temperature units to
Celsius
Set temperature units to
Fahrenheit
Read scan mode
Set scan mode
Read scan rate
Set scan rate
Secondary Menu
Read proportional band
setting
Set proportional band to n
Read heater power
(duty cycle)
Configuration Menu
Operating Parameters Menu
Read high limit
Set high limit
Serial Interface Menu
Read serial sample setting
Set serial sampling setting
to n seconds
Set serial duplex mode:
Set serial duplex mode to
full
Set serial duplex mode to
half
Set serial linefeed mode:
32
Command Command
Format Example
s[etpoint] s
s[etpoint]=n s=200.0
t[emperature] t
u[nits] u
u[nits]=c/f
u[nits]=c u=c
u[nits]=f u=f
sc[an] sc
sc[an]=on/off sc=on
sr[ate] sr
sr[ate]=n sr=1.1
pr[opband] pr
pr[opband]=n pr=8.83
po[wer] po
hl hl
hl=n hl=90
sa[mple] sa
sa[mple]=n sa=0
du[plex]=f[ull]/h[al
f]
du[plex]=f[ull] du=f
du[plex]=h[alf] du=h
lf[eed]=on/of[f]
Returned
Returned Example
set: 999.9 {C or F} set: 100.00 C
t: 999.9 {C or F} t: 55.6 C
u: x u: C
scan: {ON or OFF} scan:ON
srat: 99.9 {C or srat:12.4C/m
F}/min in
pb: 999.9 pb: 15.9
po: 999.9 po: 1.0
hl:999 hl:126
sa: 9 sa: 1
Acceptable
Values
Instrument
Range
C or F
ON or OFF
.1 to 99.9
Depends on
Configuration
50–160
0 to 999
FULL or HALF
ON or OFF