PEUGEOT BIPPER Handbook page 27

Warning lamp
Electronic anti-theft
Emissions control
system
Low fuel level
Particle emissions filter
Presence of water in
the Diesel filter
Diesel pre-heating
is indicates
the ignition key introduced
on. is not recognised.
Starting impossible.
flashing or on
a fault with the system.
continuously.
on with the gauge that the fuel reserve is
needle in zone E. being used.
on, accompanied by
the start of saturation of
an audible signal and
the particle emissions
a message in the
filter.
screen.
on, accompanied by
water in the Diesel fuel
a message in the
filter.
screen.
that the weather
conditions impose pre-
on. heating (up to around
30 seconds in extreme
climatic conditions).
Instruments and controls
Solution - action
Use another key and have the faulty key
checked by a PEUGEOT dealer.
Chapter 1, "Access".
Have it checked as soon as possible by a
PEUGEOT dealer or a qualified workshop.
Refuel without delay. The assessment of the
fuel reserve is sensitive to the style of driving,
the profile of the road, the time elapsed and the
distance travelled since the warning lamp first
came on.
Carry out a regeneration of the filter as soon as
possible. Chapter 7, "Checks".
Have the filter bled by a PEUGEOT dealer or a
qualified workshop. Chapter 7, "Checks".
Wait for the warning lamp to switch off before
operating the starter.
If the engine does not start, switch the ignition
off and on again, wait for the warning lamp to go
off, and start the engine.
1