PEUGEOT BIPPER Handbook page 138

Battery
Models with Stop & Start
A. Protective cover.
B. Positive metallic point on your vehicle.
C. Slave battery.
D. Earth on your vehicle.
E. Terminal release button.
F. Check sensor button.
G. State of charge sensor.
H. Metal negative point of your vehicle.
Charging the battery using a battery charger
Do not disconnect the battery to charge
it.
- Press the release button E to disconnect
the terminal F .
- Disconnect the connector F of the check
sensor G .
- Remove the protective cover A from the
metallic point B .
- Connect the charger cables: (+) on
the metallic point B ; (-) on the metallic
point H .
- Follow the instructions for use given by
the battery charger manufacturer.
- Check that the battery posts and
terminals are clean. If they are covered
with sulphate (white or greenish deposit),
disconnect them and clean them.
- Reconnect connector F of the check
sensor G .
- Refit the protective cover A to the
metallic point B .
Never remove the check sensor G
from the metallic point H , except
when replacing the battery.
Starting using another battery
- Remove the protective cover A from the
metallic point B .
- Connect the red cable to metallic point B ,
then the (+) terminal to the slave battery C .
- Connect one end of the green or black
cable to the (-) terminal of the slave
battery C .
- Connect the other end of the green or
black cable to the earth point D of your
vehicle (never to the metallic point H of
your vehicle).
- Operate the starter, let the engine run.
- Wait for the engine to return to idle, then
disconnect the cables.
- Refit the protective cover A to the
metallic point B .