Maximum Operating Time Exceeded; Oven Light - Thermador Professional Series Use And Care Manual

Cooling fan runs even when the oven is turned off.
Oven door closes faster/slower than normal.
The appliance cannot be switched on or is on and
cannot be operated; the
display.
The appliance does not heat up;
display.

Maximum Operating Time Exceeded

Your appliance automatically ends the operation if no
duration has been set and the setting has not been
changed for 24 hours.
The actual cooking time until the operation is stopped
automatically varies according to the selected settings.
A message appears on the display on the appliance to
say that the operation is being ended automatically.
Afterwards, the operation is stopped.
To use the appliance again, first switch it off. To switch
the appliance back on set the required operation.

Oven Light

To replace the halogen bulb on the oven sidewall:
Tools required
Turn off power to the oven at the main power supply
1.
(fuse or breaker box).
38
‚ symbol is shown on the
6 is shown on the
Narrow flat blade screw-
driver (blade tip width 1/
5" (5 mm) or less to fit in
slot).
Flashlight (to see socket
holes to plug in bulb
prongs).
G-9 Halogen bulb
This is normal. The cooling fan will continue to run, even after
the oven has been turned off, until the oven has cooled
sufficiently.
The soft-close door hinges contain a damping fluid that is
affected by temperature. If the oven is in a cold environment,
the door will close slower than it will in a warmer
environment. A warmer than normal environment, such as
when cooking, may cause the door to close slightly faster.
The panel lock is activated. Press and hold the LOCK touch
button (or TIMERS, if LOCK is not present) until the
symbol goes away.
Demo mode is activated in the basic settings. Turn demo
mode to OFF in the settings menu.
Remove three screws from oven cavity holding the
2.
rack in place.
Remove oven rack to provide access to the bulb
3.
housing.
Remove screw from top of bulb housing.
4.
‚