Greenheck DGX Installation, Operation And Maintenance Manual page 37

Water Wizard (Improper Water Supply)
NOTE!
If the water supply is too low, the media will
continuously appear dry.
Some water drainage is desirable to reduce mineral deposits but should be minimized to best utilize
Step 1 Adjust the Manual Supply Valve
Adjust the manual supply valve (refer to Water Pressure Start-Up S-9, Step #2).
Only proceed to steps two and three if the manual supply valve does not correct the problem.
Step 2 Enter Program Mode
Press and hold the Enter Key for three
seconds to enter Program Mode. The
display reads "Pro" when Program Mode is
active (see figure #60).
Step 3 Adjust the On Time Factor
While in the Program Menu, use the Up and
Down Keys to navigate through the Menu
Options until "ont" is displayed (see figure
#61). Press the Enter Key to access the
setting.
Use the Up and Down Keys to adjust the
setting as needed.
Increase the factor to increase the water
supply or decrease the factor to decrease
the water supply.
Press the Enter Key to save the On Time
Factor and return to the Program Menu.
Step 4 Exit Program Mode
After ten seconds of idle time the controller will automatically exit the Program Mode.
Troubleshooting
If the water supply is too high, the media will be
saturated and excessive water will be draining
NOTE!
the Water Wizard.
CAUTION!
Changing the On Time Factor by (1) will change
the water supply by approximately 3%.
The Enter Key must be pressed to save the new
37
NOTE!
from the sump tank.
Figure 60. Program Display
Figure 61. On Time Factor Display
NOTE!
IMPORTANT!
On Time Factor.