Installation - Magnadyne Aquavibe MD-150 Operation And Installation Manual

Installation

Installing Entertainment Center
1. Use the template included to determine the best
location for the entertainment center.
Note: The mounting location needs to be a flat
surface.
2. Cut out the mounting hole and drill pilot holes
for the screws.
Installing Wired Remote (Optional)
1. Install mounting studs into rear of remote con-
troller. Hand tighten the studs only.
2. Cut a 2-1/8" hole.
3. Insert cable from remote controller through the
hole and then mounting bracket.
4. Slide mounting bracket onto mounting studs.
Mounting
Studs
14
Use Supplied Template to Cut Hole
and Make Pilot Holes for Screws
Wing
Nuts
3. Mount the entertainment center using the pro-
vided screws. Make sure to tighten the screws
equally to create a waterproof seal.
Note: If the surface is uneven like wood, use
silicone to create a waterproof seal between the
uneven surface and the entertainment center.
4. Install the screw covers.
5. Screw the wing nuts onto the studs and hand
tighten them against the mounting bracket. Do
not use pliers to tighten the wing nuts.
Note: If the surface is uneven like wood, use
silicone to create a waterproof seal between the
uneven surface and the remote control.
Mounting
Bracket
Cable
Supplied Supplied
Mounting Screw
Covers
Screws