Reset; Inserting A Battery Into Remote Controller; Programming A Wireless Remote Controller - Magnadyne Aquavibe MD-150 Operation And Installation Manual

Reset

Resetting the System:
To reset the microprocessor to the original
factory settings use a ball point pen and press
the RESET button located in the interior of the
waterproof compartment.

Inserting a Battery into Remote Controller

Inserting a Battery:
1. Use a coin to unlock the battery cover.
2. Insert the battery with the + side of the battery
facing up.
3. Replace the battery cover and use a coin to
lock the battery cover making sure it locks
into place.
Note: When the text in the LCD is dim, replace
the battery.

Programming a Wireless Remote Controller

Programming a Wireless Remote Controller:
1. To pair the wireless remote with the dock
push and hold the MODE button on the
remote controller until "PAIR" appears in it's
display
2. While still holding the MODE button on the
wireless remote controller, press the RESET
button in the interior of the waterproof com-
partment to pair the devices.
3. If the pairing is successful, the dock will
restart and "PAIR" will disappear from the
remote's display. Release the MODE button
on the remote controller.
RDM
TRACK
SEL
MODE RPT
Reset
Aux In 1 Charge Only
Lock
Hold
RDM RPT SEL
VOL
MODE
VOL
RDM
TRACK
MODE SEL
RPT
Reset
Charge Only
Aux In 1
VOL
Coin
Battery +
Side Up
VOL
13