ACR Electronics Nauticast 2662 User Manual page 56

Input Modes for New Regions
Data Field Field Description
NE LAT(1) Latitude N/E corner
NE LON(1) Longitude of N/E corner
SW LAT(2) Latitude of S/W corner
SW LON(2) Longitude of S/W corner
TrZone(3) Transitional Zone Size
ChannAIS1 Primary AIS Channel
Bandwidth for Primary AIS
BandwAIS1
Channel
ChannAIS2 Secondary AIS Channel
Bandwidth for Secondary
BandwAIS2
AIS Channel
Tx/RxMode Channel Modes
VHF Power VHF Power Settings
c) Alarm Settings
This screen allows the user to enable or disable the generation and display of Alarms.
Alarms are displayed in the Alarm Inbox (see Menu 5: Transponder Configuration, Submenu
3: Alarm Settings) and on the ECDIS screen.
NOTE: It is highly recommended to enable the alarm function.
Dynamic Keys: Alarm Settings
[M5] [Save]
[M6] [Change]
A detailed listing of the possible alarms can be found in paragraph 5.2.
Y1-03-0211 Rev D
o o
N 1 19' E 0 12' |1>0.10|2>1.30|3>1.80nm
************ Alarm Settings ************
on/off
Alarm generation: [*]/[ ]
Note: This setting also affects output
on ECDIS port.
----------------------------------------
| Save | Change
Save Alarm Settings [Back]
Configure
Generation (on/off)
Input Modus Additional Information
Manual Input Degrees and minutes
Manual Input Degrees and minutes
Manual Input Degrees and minutes
Manual Input Degrees and minutes
<Selection> Nautical Miles
Manual Input Channel Number
Default Setting as defined by
<Selection>
the channel number
Manual Input Channel Number
Default Setting as defined by
<Selection>
the channel number
Tx : Transmitting Mode
<Selection>
Rx: Receiving Mode
Low = 2 Watt
(Default for Ports)
<Selection>
High = 12,5 Watt (Default for
High Sea Regions)
| | Back
Return to Submenu
Configuration
Alarm
52