Management Vlan; Figure 4-42 Wireless - Rssi Threshold; Figure 4-43 Wireless - Management Vlan - Planet WBS-502AC User Manual

and then you can configure the Guest Network Settings
and then you can configure the RSSI Threshold
The RSSI Threshold is used when a weakening wireless link between AP and client is detected below the is used when a weakening wireless link between AP and client is detected below the is used when a weakening wireless link between AP and client is detected below the
specific RSSI, the AP will encourage client to access the nearby AP with stronger signal, thus ensure stable specific RSSI, the AP will encourage client to access the nearby AP with stronger signal, thus ensure stable specific RSSI, the AP will encourage client to access the nearby AP with stronger signal, thus ensure stable
wireless connectivity.
The page includes the following settings The page includes the following settings:
Object
• Status
• RSSI (Received Signal
Strength Index)

4.5.7 Management VLAN

Go to the "Network Wireless" page to configure the device as
and then you can configure the Management VLAN
If your network includes VLANs and if tagged packets need to pass through the Access Point, If your network includes VLANs and if tagged packets need to pass through the Access Point, If your network includes VLANs and if tagged packets need to pass through the Access Point, enable the
management VLAN settings and enter the
The page includes the following settings The page includes the following settings:
Object
Guest Network Settings in the bottom of the page.
RSSI Threshold in the bottom of the page.
Figure

Figure 4-42 Wireless - RSSI Threshold

Description Description
Click Click Enable to enable the RSSI Threshold.
Specifies the Specifies the RSSI value to limit the client access. to limit the client access.
Range: Range: -60dBm ~ -100dBm
RSSI is an indication of RSSI is an indication of the power level being received by the antenna. the power level being received by the antenna.
Therefore, Therefore, the higher the RSSI number, the stronger the signal. the higher the RSSI number, the stronger the signal.
page to configure the device as "Access Point" or "WDS
Management VLAN Settings in the bottom of the page.
enter the VLAN ID. Otherwise, keep it disabled.
Figure Figure 4-43 Wireless – Management VLAN
Description Description
-58-
User Manual of Manual of WBS-502AC
WDS Access Point" mode
page.