Table of Contents
Advertisement
•
Check transducer cable connections to the MFD or to the CAN
network.
•
Check that the correct depth source is selected. (Run a new
source selection.)
AP Heading data missing*
Probable cause: Missing or invalid heading data.
Recommended action:
•
Check the compass cable connections to the CAN network.
•
Check that the correct heading source is selected. (Run a new
source selection.)
AP Nav data missing*
Probable cause: Missing or invalid NAV data.
Recommended action:
•
Check for valid data on the MFD screen.
•
Check the source selection setting.
AP Rudder data missing (For Helm-1/ cable steer only)*
Probable cause:
•
Rudder feedback signal missing due to a broken wire or
connection.
•
Misaligned potentiometer in the Helm-1.
Recommended action:
•
Check cable and connector.
•
Check the alignment as per the installation instructions.
AP Off course*
Probable cause:
•
The boat's heading is outside the fixed off course limit of 20 deg.
(Automatic reset when inside limit).
•
The boat speed is too low.
•
The response setting is too low.
Recommended action:
•
Check the steering response setting and increase the steering
response setting.
•
Increase the boat speed if possible, or steer by hand.
AP clutch overload (For Helm-1/ cable steer only)*
Probable cause: The clutch in Helm-1 is drawing too much current.
Software setup
| HDS Live Installation Manual
43
Hide quick links:
Advertisement
Table of Contents
