Lowrance HDS Live Installation Manual page 33

X
Adjust bearing alignment
This option is used to align the heading marker on the screen with
the center line of the vessel. This will compensate for any slight
misalignment of the scanner during installation.
Misalignment that is not corrected for will compromise target
tracking and can result in dangerous misinterpretation of potential
navigation hazards.
Any inaccuracy will be evident when using MARPA or chart overlay.
1
Point the vessel towards a stationary isolated object, or
towards a far range AIS where the AIS icon matches the radar
echo
2
Adjust the coarse and fine bearing alignment so that the
heading line touches the end of the selected object
Sidelobe suppression
Occasionally false target returns can occur adjacent to strong target
returns such as large ships or container ports. This occurs because
not all of the transmitted radar energy can be focused into a single
beam by the radar antenna, a small amount energy is transmitted in
other directions. This energy is referred to as sidelobe energy and
occurs in all radar systems. The returns caused by sidelobes tend to
appear as arcs.
Ú Note:
This control should only be adjusted by experienced
radar users. Target loss in harbor environments may occur if this
control is not adjusted correctly.
Software setup | HDS Live Installation Manual
X
33