Lubricate Rear Axles - Simplicity Broadmoor 16HP V-Twin Operator's Manual

Figure 24. Arbor Lubrication Points

LUBRICATE REAR AXLES

We recommend removing the rear wheels and lubricat-
ing the axle shafts yearly. This prevents the wheel from
seizing onto the axle shaft, making future service easier.
1. Remove the key and disconnect the spark plug wire
while working on the unit.
2. Engage the parking brake and block the front wheels.
3. Using a jack or chain hoist positioned at the center of
the rear frame, carefully jack the unit up until the rear
tires are approximately 1" - 2" off the ground.
NOTE: For overall unit stabilify during service, do not
jack rear end higher than required for wheel removal.
4. Support the rear of the unit on jack stands positioned
under the rear frame (see Figure 26).
5. Remove the plastic hub cap (G, Figure 27).
6. Remove e-ring (F, Figure 27) using a screwdriver.
7. Remove the washers (D) and wheel (C).
NOTE: Your ax/e assembly may diffei s!ightly from the
assembly pictured: washer (0, Figure 27) may be miss-
ing or doubled. This is adjusted on a tractorby tractor
basis during assembly to allow a small amount of ax/e
end-play.
8. Lubricate the axle shaft with anti-seize compound or
lithium grease.
9. See Figure 27 for assembly. Reinstall components in
reverse order of disassembly and lower the unit. Be
sure the key (H) is in place in the axle key-way.
Figure 25. Mower Lubrication Points
Figure 26. Elevate the Rear End
Figure 27. Wheel and Axle Assembly
A. Washer
C. Wheel
D. Washer
19
Regular Maintenance
E. Hub Cap Retainer
F. E-Ring
G. Hub Cap