Advertisement
ACCESS CODE
The access code (1 to 4 digits) is recommended to set sensors installed close to each other.
SAVING AN ACCESS CODE:
Once you have saved an access code, you always need to enter this code to unlock the sensor.
DELETING AN ACCESS CODE:
ERASE AN UNKOWN ACCESS CODE:
TROUBLESHOOTING
The door remains
closed.
The LED is OFF.
The door does not
react as expected.
The door opens
and closes
constantly.
The door opens for
no apparent reason.
The vehicle detection
filter is used, but
pedestrians are still
detected.
The LED
flashes quickly
after unlocking.
The sensor does
not respond to the
remote control.
SAFETY INSTRUCTIONS
The manufacturer of the door system is responsible for carrying out a risk assessment and installing the sensor and the door system in compliance with
applicable national and international regulations and standards on door safety.
Only trained and qualified personnel may install and setup the sensor.
The warranty is void if unauthorized repairs are made or attempted by unauthorized personnel.
BEA hereby declares that the FALCON is in conformity with the basic requirements and the other
relevant provisions of the directives 1999/5/EC and 2004/108/EC.
The complete declaration of conformity is available on our website: www.bea.be
Only for EC countries: According the European Guideline 2012/19/EU for Waste Electrical and Electronic Equipment (WEEE)
24/7 Tech Support: 1-800-407-4545 | Customer Service: 1-800-523-2462 | General Tech Questions: Tech_Services@beainc.com | Tech Docs: www.beasensors.com
For more information, please visit www.devancocanada.com or call toll free at 855-931-3334
If you do not know the access code, cut and restore the power
supply. During 1 minute, you can erase an unkown access code:
The sensor power is off.
Improper output
configuration on the sensor.
The sensor is disturbed
by the door motion or
vibrations caused by the
door motion.
The sensor detects raindrops
or vibrations.
In highly reflective
environments, the sensor
detects objects outside of its
detection field.
The chosen value is not
optimal for this application.
The sensor needs an access
code to unlock.
The remote control
batteries are weak or
improperly installed.
Check the wiring and the power supply.
1
1
Check the output configuration setting on each
sensor connected to the door operator.
1
Make sure the sensor is fixed properly.
2
Make sure the detection mode is unidirectional.
3
Increase the tilt angle.
4
Increase the detection filter value.
5
Reduce the field size.
1
Make sure the detection mode is unidirectional.
2
Increase the detection filter value.
1
Change the antenna angle.
2
Decrease the field size.
3
Increase the detection filter value.
1
Increase the detection filter value.
2
Decrease the sensor angle.
3
Increase the installation height.
4
Make sure the detection mode is unidirectional.
1
Enter the right access code.
If you do not know the access code, cut the power
2
supply and restore it to access the sensor and
change the access code or delete it.
1
Check the batteries and change them
if necessary.
75.5835.04 FALCON FAMILY 20160301
Advertisement
