Operation; Fuse Exchange - Kenwood KSC-PSW8 Instruction Manual

Installing the remote control unit
Install the remote control unit on the vehicle by the
provided hook-and-loop fastener.
① Remote control
Vehicle
⑨ Hook-and-loop
fastener
⑨ Hook-and-loop
(Harder surface)

Fuse exchange

Exchange with the specifi ed capacity
fuse.
Removal
Fuse
Cover
Fuse holder
❶ Open the cover.
❷ Grasp the fuse and pull up.

Operation

Name of each part (Remote control )
Illumination
When the power turns ON, the illumi-
nation lights.
VOLUME control knob
(Input sensitivity control knob)
FREQUENCY control knob
(Cut-off frequency control knob)
PHASE switch
(Phase select switch)
Note:
Large power input will cause the protection circuit for this unit
to operate, which will decrease output level. In this case, turn
the volume to "MIN" for a while, then eventually this unit will
automatically start working again.
The sound is output even when the remote control unit is
not connected, but the operations described in this section
are not available. In this case, the volume, cut-off frequency
and phase are set to the predetermined default conditions,
with which the cut-off frequency is 125 Hz and the phase
is 0° (positive).
(Rear panel)
fastener
(Softer surface)
Caution: Be sure to replace with same capacity (amperage) as displayed on the
fuse. This product is 10A.
Caution:
Install the remote control unit in a position that does not
come in the way of driving operations.
Avoid installing it in a place subject to direct sunlight or
direct hot wind from the heater. Otherwise, the product
may be degraded and a fi re hazard may result.
Remove dirt from the installation position before attaching
the hook-and-loop fastener.
Insertion
Replacement
fuse 10 A
❶ Insert the fuse gently into the fuse holder and push
in all the way with your fi nger.
❷ Close the cover.
Adjusting the sound
(Remote control operation)
❶ Turn the FREQUENCY control knob to adjust the
cut-off frequency (frequencies higher than this
frequency are cut off ).
Turn the FREQUENCY control knob to adjust the balance between
the bass from the rear speakers and the bass from this unit as
desired.
50 Hz
Sound pressure
level
Low
Frequency
❷ Adjust the low frequency phase.
The low frequency tone may be variable depending on the position
of the unit, its orientation or the turn-over frequency. This can be
adjusted by changing the position of the PHASE switch. Set this
switch to either position according to your liking.
[0°] indicates the normal phase and [180°] means the reverse phase.
❸ Turn the VOLUME control knob to adjust the low
frequencies to the desired level.
To decrease
volume
125 Hz
Low
High
High
To increase
volume
English
7