Operation - Kenwood KSC-WD250T Instruction Manual

Operation

■ Name of each part
Power indicator
LINE IN terminal (RCA pin jack)
REMOTE terminal
PHASE
FREQUENCY
■ Power Indicator
Blue glows
[Power ON ]
■ Fuse exchange
Exchange with the specified capacity fuse.
Removal: Grasp with your fingers and pull up.
Insertion: Insert the fuse gently into the fuse holder and push in all
the way with your finger.
Caution: ––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Be sure to replace with same capacity (amperage) as displayed on the fuse.
This product is 5A.
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Power Supply/Control Input/Terminal (for
Speaker Cords)
LEVEL
Light is OFF
[Power OFF ]
Fuse
Fuse holder
Replacement fuse 5A
■ Basic operation
1. Set the crossover frequency.
Turn the LOW PASS FREQUENCY control knob to adjust the
balance between the bass from the rear speakers and the bass
from this unit as desired.
2. Adjust the low frequency level.
Turn the knob to the desired level.
3. Adjust the low frequency phase.
The low frequency tone may be variable depending on the
position of the unit, its orientation or the crossover frequency. This
can be adjusted by changing the position of the PHASE switch. Set
this switch to either position according to your liking.
● Crossover frequency: The frequency at which the high range
is cut off.
MAX
MIN
LOW
FREQUENCY
● Connecting the remote control unit
3 Remote control unit
When connecting the cord, align the jacks
as shown below.
● Installing the remote control unit
Install the remote control unit on the vehicle by the provided Velcro tape.
Vehicle
4 Velcro tape
(Hook surface)
Caution: ––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Install the remote control unit in a position that does not come in the way of
driving operations.
Avoid installing it in a place subject to direct sunlight or direct hot wind
from the heater.
Remove dirt from the installation position before attaching the Velcro tape.
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
50Hz
80Hz
100Hz
150Hz
HIGH
Mini-Din REMOTE CONTROL
3 Remote control unit
4 Velcro tape
Rear panel
(Loop surface)
80 100
50 150
(Hz)
FREQUENCY
MIN MAX
LEVEL
PHASE
English 5