Test Power Supply Resistance; Test Resistor Stud Resistance - Graco 236685 Instructions And Parts List

Test Power Supply Resistance (See Fig. 17)
Remove the power supply (27) from the gun body (29)
as instructed on page 35.
Measure the resistance from the power supply's
ground contact point (R) to the contact inside of the
power supply seal (D) [the conductive rubber contact
may be slightly recessed into the seal].
The resistance should be 297 to 363 megohms. If the
resistance is outside the specified range, the power
supply is defective and must be replaced. If the resis-
tance of the power supply is correct, proceed to the
next test.
NOTE: Be sure the seal (D) is in place on the end of
the power supply before installing the power supply
back into the gun.
Test Resistor Stud Resistance (See Fig. 18)
Remove the resistor stud (15) as instructed on page
29. Check the resistance between the black resistor
stud ring contact (S) and the needle contact ring (T).
You may have to press down on the contact ring (S) in
several places to get a good reading.
The resistance should be 21 to 29 megohms. If the
resistance is correct, make sure the metal contact in
the gun barrel and the needle contact ring (T) are
clean. If the resistance is outside the specified range,
the resistor is defective and the resistor stud (15) must
be replaced. See page 29 to replace the resistor stud.
WARNING
FIRE, EXPLOSION, AND
ELECTRIC SHOCK HAZARD
The resistor stud contact ring (S) is a
conductive contact ring, not a sealing
o-ring. See Fig. 18. To reduce the risk of
sparking, which could cause a fire,
explosion, or electric shock, do not
remove the resistor stud contact ring (S)
or operate the gun without the contact
ring in place. If the resistor stud (15) is
being replaced, only use a genuine
Graco part.
Electrical Tests
Fig. 17
Fig. 18
D 27
15
T
L
R
0441
S
0442
308442 27