Initial Start-Up And Functions; Input Sensitivity; Output Channels; Line Output - HELIX V EIGHT DSP Manual

Initial start-up and functions

9 Input Sensitivity

control range of the RCA / Line Input is 2 - 4 Volts
and 5 - 10 Volts for the Highlevel Input. The input
Attention: It is mandatory to properly adapt the

Output Channels

10
Speaker outputs to connect speaker systems. The
impedance per channel must not be lower than
2 Ohms.
Important: We highly recommend to make the gen-
eral settings in the DSP PC-Tool software before
wrong setup can destroy your tweeters right away.
GND
11
The ground cable should be connected to a com-
mon ground reference point (this is located where
which has been cleaned of all paint residues. Rec-
ommended cross section: min. 16 mm² / AWG 6.
REM
12
The remote input has to be used to turn on/off the
V EIGHT DSP if the signal source which is connect-
ed to the Highlevel Input
18
to the remote input. The remote lead should be con-
nected to the remote output / automatic antenna
er with the head unit. This input needn´t to be as-
signed if the Highlevel Input
+12 V
13
minal of the battery. Recommended cross section:
min. 16 mm² / AWG 6.

Line Output

14
amps by a signal from the ignition switch of your
car! Additionally this output will be turned off when
The outputs can be assigned to any of the inputs as
desired using the DSP PC-Tool software.
Rem Out
15
We strongly recommend to use this output for turn-
the Line Output of the HELIX V EIGHT DSP. This is
ing process of the DSP is completed. Additionally
-
-
-
-
-
-
Rem Out
-
-