Initial Start-Up And Functions - HELIX C ONE Manual

Initial start-up and functions

1 Optical Input (optional)
Optical input in SPDIF format for connecting signal
sources with a digital audio output. The sampling
rate of this input must be between 28 and 96 kHz.
Please note: The digital input is not part of the
C ONEs standard equipment. This can only be ret-
Input Module HDM 1.
Important: The signal of a digital audio source nor-
mally does not contain any information about the
sources!
Note:
signals and no MP3- or Dolby-coded digital audio
stream!
Note: It is possible to use the Optical Input and the
Line Input at the same time.
2 SPDIF Direct In switch (optional)
Due to the SPDIF Direct In switch, the input stages
of the C ONE can be bypassed and the input sig-
nal of the Optical Input directly and losslessly rout-
SPDIF Direct In switch to "On".
Please note: The SPDIF Direct In function is not
part of the C ONEs standard equipment. It is solely
put Module HDM 1.
Note:
the Optical Input.
Note:
mode for routing the digital input signal directly to
the power stage. Therefore change the position of
the X-Over switch to "FULL" (see page 21, item 23).
Note:
el Line Input (3) as well as the Level control (16) are
without function!
3 Line Input
sourc es such as head units / radios / DSPs.
4 GND
The ground cable should be connected to a common
ground reference point (this is located where the
been cleaned of all paint residues. Recommended
cross section: min. 16 mm² / AWG 6.
5 +12 V
minal of the battery. Recommended cross section:
min. 16 mm² / AWG 6.
6 REM
-
The remote lead should be connected to the remote
if the head unit / car radio is switched on. Thus the
head unit / car radio. As soon as there is an addi-
tional digital signal processor (DSP) implemented in
the signal path, the remote output of the DSP has to
be used to turn on the C ONE.
7 TwinPower Link switch
the output power is more than doubled, depending
ed with a RCA / Cinch cable (see page 19, item 8;
Mono RCA/Cinch In- / Output
- is set as "Master" assumes the complete control
Attention:
mode the minimum speaker impedance is 2 Ohms.
Note:
- Power Link switch must be set to "Master".
Link mode can be found on page 26.
8 Mono RCA/Cinch In- / Output
mode (see page 19, item 7; TwinPower Link switch).
-
-
TwinPower Link by which
-
Twin-
19