Accessories On Select Models - Safety 1st MultiFit Manual

2. Thread Harness Straps
into Shoulder Harness
Slots
If you will be using the lower
shoulder harness slots for smaller
infants, see pages 9-11.
3. From Back, Thread
Harness Straps OVER
Metal Bar
DO NOT twist harness straps.
4. Attach 1st Harness Strap
Loops to Splitter Plate
As Shown
Sewn ends of the harness strap
loops
DO NOT twist harness strap or
harness adjustment strap.
Make sure the same harness strap
loops are fitted COMPLETELY ON
both sides of the splitter plate.
sewn
end
Correct
WARNINGS:
Harness system must be installed
correctly. Failure to follow these steps can result in serious
injury or death.
23
MUST face towards you.
XXXXX

Accessories on Select Models

Removable Cupholder
To remove cupholder, twist the cupholder
counterclockwise.
Pull out of slot in shell.
The cupholder is dishwasher safe.
To install cupholder, align tabs on bottom
of cupholder with slots in shell. Twist clock-
wise to lock in place.
Body Pillow
When using the lower shoulder harness
slots for smaller infants, you
the body pillow.
To remove body pillow, slide pillow out
from behind the harness straps.
Or from the back of seat, remove harness
strap loops from splitter plate. From the
front, pull harness straps out of shell and
body pillow.
Rethread harness straps: For lower
shoulder harness slots for smaller
infants, see pages 9-11. For upper
shoulder harness slots, see page 23.
MUST use
24