Accessories On Select Models; Child Restraint Use; Installation In Vehicle - Safety 1st Grow and Go Air Instructions Manual

Accessories on Select Models

Head Pillow
To remove head pillow, pull it up from
behind the body pillow.
You must use the back body pillow in order
to use the head pillow.
Harness Covers
Harness covers help provide comfort to the
neck. If harness covers will not allow proper
positioning of the chest clip or interfere with
getting a tight enough fi t for a smaller baby,
remove and do not use.
Store until child is large enough to use these
harness covers while maintaining a properly fi tting harness.
To remove harness covers, pull the fastening strips apart and remove
harness covers.
Body Pillows
When using the lower shoulder harness
slots for smaller infants, you
body pillow.
To remove body pillow, pull buckle through
the slot in bottom pillow and slide both pillows
out from behind the harness straps.
Or if the lower shoulder harness slots were used, from the back of seat
remove harness strap loops from splitter plate. From the front, pull har-
ness straps out of shell and back body pillow. Pull buckle through slot
in pillow. Rethread harness straps: For lower shoulder harness slots
for smaller infants, see pages 9-11. For upper shoulder harness
slots, see page 24.
25
4358-6835 Grow and Go Air.indd 31-32 4358-6835 Grow and Go Air.indd 31-32

Child Restraint Use

Do not use this child restraint unless the child is 5-100 lb
(2.3-45.4 kg) and 19-52 in. (48-132.1 cm).
Never take your child out of the child restraint while the
vehicle is moving.
Never leave child unattended.
Placing your child in a hot child restraint may result in
burns.
Do not use a child restraint with damaged or missing parts.
Do not use cut, frayed or damaged harnesses.
Do not substitute parts or try to modify the child restraint in
any way.
Do not lubricate buckles and fasteners.
Do not use any child restraint accessory except those
approved by Dorel Juvenile Group.
Never allow any child to play with this child restraint; it is
not a toy.
Do not remove or cover up any of the warning labels or
other labels on the child restraint.
Read all instructions for additional warnings.
On the side of the child restraint there is a date of manufac-
ture label. Do not use this child restraint more than 10 years
after the date of manufacture.
MUST use the

Installation in Vehicle

Check the vehicle belt or lower anchor belt before each use.
Use only if the belt is tightened properly and locked securely
in place.
This child restraint should be securely belted in the vehicle
even when not in use. In a crash or sudden stop, an unse-
cured child restraint could injure occupants.
Do not use a child restraint that has been in a crash. You
must get a new child restraint.
26
10/29/15 3:33 PM 10/29/15 3:33 PM