Configuration
Setting the time
The LCD display q shows you the time of day. You set this
as follows:
1. Hold down the SET button e for a little longer than
3 seconds.
2. With the or button h select "CONFIG" and
confirm with the OK button l.
3. In the LCD display q appears "TIME SETUP". Confirm
with the OK button l. The LCD display q now shows
"TIME" and the first number of the hour display blinks.
4. With or h place the cursor on the position, in
which you want to make an entry and press the number
buttons o to set the hour and minutes. The switching be-
tween AM and PM you undertake with the or but-
ton h. Thereby "AM" stands for "ante meridium"
(= morning, 0:00 to 12:00 o'clock) and "PM" stands for
"post meridium" (= afternoon, 12:00 to 0:00 o'clock).
5. With the OK button l you save the setting. In the LCD
display q appears "SUCCESS" and the previous mode
is accessed again. In the event of an error the LCD
display q shows "ERROR".
6. To exit this menu press repeatedly the EXIT button j
until the standard display appears in the LCD display q.
Adjust contrast
You can set the display's contrast as follows:
1. Hold down the SET button e for a little longer than
3 seconds.
2. With the or button h select "CONFIG" and
confirm with the OK button l.
3. With the or button h select "CONTRAST" and con-
firm with the OK button l.
4. With the or h button you set the contrast (
reduces the contrast, increases the contrast).
Display readout:
0 = highest contrast
15 = lowest contrast
5. With the OK button l you save the desired setting.
In the LCD display q appears "SUCCESS" followed
by "CONTRAST".
6. To exit this menu press repeatedly the EXIT button j
until the standard display appears in the LCD display q.
- 9 -