Electrical Data; Electrical Requirements - Thermador PH30HWS Installation Instructions Manual

Blower Motors
Integral, In-line and Remote blowers are available through
your authorized Thermador
information, visit the Find a Dealer section of our website
at www.thermador.com.
The blower performance options will vary in cubic feet per
minute (CFM) and is dictated by the cooking surface, the
volume of air that needs to be moved and the length of
the duct run. Refer to the "Blower Motor Installation"
section for detailed blower motor information.
Support Structure
Due to the weight of the hood, make sure the wood
mounting bracket is attached to all available wall studs.
Framing must be fastened together and to ceiling joists to
provide enough structural strength to support the weight
of the hood and internal blower, if applicable.
Wall framing should be, at minimum, made of 2"x 4"
lumber. Proper structural support is required to
accommodate the weight of the hood.

Electrical Requirements

The unit requires a 120V AC, 60Hz. 15A branch circuit. The
VTR1330 blower in conjunction with a PHxxGWS requires
a 20 amp circuit breaker. The hood should only be
connected to a dedicated circuit (with ground) that has
been installed according to relevant regulations.
When connected to a GFCI-protected supply, Thermador
®
Professional hoods are suitable for use in damp locations
that are protected from outside weather conditions and
not subject to saturation with water and other liquids, but
can be subject to moderate degrees of moisture (such as
an outdoor covered patio or lanai area). Refer to local
codes, NEC/CEC, and or the Authority Having Jurisdiction
(AHJ) for additional information.
Check your local building codes for proper method of
installation. In the U.S., this unit should be installed in
accordance with applicable local codes or, in the absence
of local codes, with the National Electrical Code, NFPA 70
or the Canadian Electric Code, CSA C22.1-02.
WARNING
The appliance must be grounded.
®
dealer. For local dealer
NOTE: The 25 ft. Remote and In-line Blower Extension
Cable accessory (EXTNCB25W) will only work for
distances up to 25 ft. The accessory cable must be
purchased separately. DO NOT use more than one Blower
Extension Cable per installation.

Electrical Data

Data, including the model and serial number, is located on
the product data rating label inside the appliance, visible
after removal of the filter frame (see "Product Data Rating
Label").
Page. 9