Installing Grease Trays, Filters And Spacers; Heat Lamp Installation (Some Models) - Thermador PH30HWS Installation Instructions Manual

Installing Grease Trays, Filters
and Spacers
View may vary
1
2
6
(1) Hood canopy
(3) Touch control panel
(5) Baffle filters
(7) Grease tray trough
Install Filters and Grease Trays
NOTE: DO NOT use burners, elements, or oven while
hood is disassembled.
1. Turn the fan and lights off.
2. Remove all plastic from hood pieces.
3. Insert in the following order:
• Grease Tray — Insert in rear tray. Grease trays
must be in place before installing the filters. Push
the grease tray in and down inside the grease tray
trough.
Page. 22
3
4
5
8
7
(2) LED lights
(4) Heat lamps
(6) Grease trays
(8) Filter spacers
• Filters — start with inserting the filter in the
middle and work out to the ends. Slide the filter
up, toward the front of the hood, then push down
on top of the grease tray .
2
3
1
• Filter spacers — If applicable, insert the filter
spacers on the left and right ends. Push up, slide
toward the front of the hood, then push in at the
bottom.
4. Reverse the above directions to remove the grease
tray, filters and filter spacer. Ensure filters are cool and
grease has congealed before removal.
Heat Lamp Installation
Note: Only on PHxxGWS models.
• Turn heat lamp clockwise to install.
• Replace lamp with either a PAR-38 175W heat lamp or
a PAR-40 250W heat lamp.
Refer to the Use and Care Guide for additional
information.