Bissell STAINPRO 1623 SERIES User Manual page 12

Operation
Ready Tools™
5. Vacuum thoroughly to pick up loose debris
and pet hair. Use a vacuum with a brush
attachment and a crevice tool to clean in
fabric folds and tufts.
6. To begin cleaning with attachments, follow
the instructions on pages 9-10 for filling the
2-in-1 water tank.
7. Set the ReadyTools dial to the TOOLS
setting. This will allow spray and suction
from the hose.
8. Attach the cleaning tool to the end of the
hose.
9. Clean by pressing the trigger to spray
solution onto the area to be cleaned. Slowly
move the tool back and forth over the soiled
surface. Release the trigger to suction dirty
water. Continue to clean in the area, working
in small sections, until dirt is removed.
Caution: Do Not Overwet.
10. When finished cleaning, remove and rinse
tool(s) in clean, running water.
11. It is recommended that you suction clean
water from a bowl to rinse out the hose.
12. Before wrapping hose onto tool rack, lift end
of hose and stretch out to ensure all water is
cleared from hose.
13. Wrap flex hose around tool rack.
14. Empty 2-in-1 water tank and rinse out,
following instructions on page 11.
15. If the ReadyTools dial becomes difficult
to turn, the diverter assembly that holds
the dial may need to be cleaned. To clean,
first remove nozzle and locate screw that
holds the diverter assembly in place. With a
Phillips screwdriver, remove the screw and
set aside.
16. Remove diverter assembly; hold under
running water making sure water flows
through and around the dial. Turn the dial
about 10 times clockwise and 10 more times
counter clockwise. This should free up any
debris.
17. Wipe diverter assembly with a soft cloth and
replace back on machine. Replace nozzle.
18. Return ReadyTools dial to FLOOR
CLEANING setting.
12
www.BISSELL.ca
7.
12.
Run water
through here
15. 16.
Screw