Bissell STAINPRO 1623 SERIES User Manual page 11

Operation
Empty the 2-in-1 water tank/ clean
removable nozzle
1.
Turn power switch OFF. Remove the 2-in-1
water tank from the base using the tank
carry handle. Carry the tank like a bucket
to a utility sink or outside where you will
dispose of the collection water. Remove
the top of the tank by rotating the handle
forward to unlatch lid and lifting lid off tank.
2. Empty collection water from bottom of tank.
3. After each use, remove and rinse the lint
screen located on the tank lid.
4. If nozzle needs to be cleaned: remove by
grasping handle at the top and pulling
forward. Clean removable nozzle by rinsing
under running water.
5. When finished, replace nozzle by slightly
raising front of machine to line up slots on
the base with the hooks on nozzle. Attach at
base first and then click nozzle into place.
NOTE: If nozzle is not attached properly
loss of suction will occur.
6. To continue carpet cleaning, refer back to
pages 9 through 10, beginning with "Fill the
2-in-1 water tank" on page 9.
If cleaning is complete, refer to the
"Maintenance and care" section on page 13.
Ready Tools™ cleaning
with attachments
Your deep cleaner comes equipped with a
hose and an attachment for cleaning stairs,
upholstery, and more.
Important! If using the machine to clean
upholstery, check upholstery tags.
1.
Check manufacturer's tag before cleaning.
"W" or "WS" on the tag means you can use
your PowerSteamer. If the tag is coded with
"X" or "S" (with a diagonal strike through),
or says "Dry Clean Only," do not proceed. Do
not use on velvet or silk. If manufacturer's
tag is missing or not coded, check with your
furniture dealer.
2. Check for colorfastness in an inconspicuous
place.
3. If possible, check upholstery stuffing.
Colored stuffing may bleed through fabric
when wet.
4. Plan activities to give upholstery time to dry.
1. 2.
Lint Screen
4.
3.
5.
Manufacturer's
tag
www.BISSELL.ca
11