5.5 Parameter Setting
Items to be Set:
Data reset
Setting Preparation
When the display is active, pressing the "mode" key two times (the interval
between the two pressing actions should be shorter than 0.3 seconds), the system will
enter the MENU parameter setting state, in which the display parameters can be set.
Press the "mode" key two times (the interval between the two pressing actions
should be shorter than 0.3 seconds) again to exit the parameter setting state.
km/mile
Light sensitivity
Wheel
Change of
diameter
speed limit
selection
Enter the Parameter Setting Interface
Backlight
brightness
Input of the
password
53
Automatic off time
Maintenance
warning settings