Omron V700-HMC71 Operation Manual page 20

(7) NACK
When the User board was not able to receive a response correctly, NACK is
transmitted to demand that the response to be transmitted again. When the R/w
Module receives this command, the most recent response will be transmitted
again.
n Command
Terminator
Command
"1" "2" Cr
n Response
The most recent response will be transmitted again.
(8) STOP
The STOP command is used to stop the R/W Module from executing a
command. When the R/W Module receives this command, it immediately stops
the execution of the current command and sets on stand by mode for a new
command.
n Command
Command Terminator
"1" "3" Cr
n Response
Completion Code Terminator
"0" "0"
(9) Oscillation ON / OFF
The Oscillation ON / OFF command specifies the oscillation of the antenna.
n Command
Oscillation ON
Command Terminator
"1" "4" Cr
n Response
Completion Code Terminator
"0" "0"
Cr
Oscillation OFF
Command
"1"
Cr
(20/23)
Terminator
"5" Cr