Installation; System Requirement; Choosing A Place For The Adsl Router - Siemens CL-110 User Manual

Chapter 2: System Requirement and

System Requirement

To access the ADSL Router via Ethernet, the host computer must meet the following requirements:
The ADSL Router is configured with the default IP address of 192.168.1.1 and subnet
mask of 255.255.255.0. As the DHCP server is Enable by default, The DHCP clients should
be able to access the ADSL Router. Or you could assign an IP address to the host PC first for initial
configuration.
You also can manage the ADSL Router through a web browser-based manager: ADSL ROUTER
CONTROL PANEL. The ADSL Router manager uses the HTTP protocol via a web browser to
allow you to set up and manage the device.

Choosing a place for the ADSL Router

With Ethernet network interface.
Must have TCP/IP installed.
Set client PC with obtain an IP address automatically or set fix IP address.
With a web browser installed: Internet Explorer 5.x or later.
To configure the device via web browser, at least one properly-configured PC must be
connected to the network (either connected directly or through an external hub/switch
to the LAN port of the device).
Place the ADSL Router close to ADSL wall outlet and power outlet for the cable to reach it
easily.
Avoid placing the device in places where people may walk on the cables. Also keep it away
from direct sunlight or heat sources.
Place the device on a flat and stable stand.
Chapter 2:System Requirement and Installation

Installation