Siemens BACNET 125-699 Owner's Manual page 34

Siemens BACnet Heat Pump Controller - Multi-Stage Owner's Manual
Description Address
SWITCH DBAND 90
NGT MA CTL {91}
CTL STPT {92}
MA STPT {93}
EHEAT 2 ON 94
EHEAT 3 ON 95
CAL TIMER 96
AOV 3 {97}
LOOP TIME 98
ERROR STATUS {99}
CLG D GAIN 102
CLG BIAS 103
HTG D GAIN 104
HTG BIAS 105
1. Points not listed are not used in this application.
2. Point numbers that appear in brackets { } may be unbundled at the field panel.
26
Application
2583, 2584 Temperature range in degrees that is compared to the
difference between CTL TEMP and CTL STPT. The
difference must exceed this value for temperature control
mode to change over. Changeover is also subject to the
active temperature control loop output being below SWITCH
LIMIT and SWITCH TIME being expired.
2583, 2584 YES indicates that mixed air control should occur during
night mode. NO indicates that mixed air control will not
occur during night mode.
Valid input: YES or NO.
2583, 2584 Actual setpoint value being used as input for the active
temperature control loop.
2583, 2584 Setpoint of the mixed air control loop.
2583 Value, in percent, that the heating loopout must exceed for
the second stage of electric heat to turn ON.
2583 Value, in percent, that the heating loopout must exceed for
the third stage of electric heat to turn ON.
2583, 2584, 2590 Time interval, in hours, between the calibration sequence.
2583, 2584, 2590 Analog output 3 controls a 0 to 10V signal.
2583, 2584 Time, in seconds, between control loop calculations.
2583, 2584, 2590 Status code indicating any errors detected during controller
power up. A status of 0 indicates there are no problems.
2583, 2584 Derivative gain value for the cooling temperature control
loop.
2583, 2584 Biasing of the cooling temperature control loop.
See CLG LOOPOUT.
2583, 2584 Derivative gain value for the heating temperature control
loop.
2583, 2584 Biasing of the heating temperature control loop.
See HTG LOOPOUT.
Description
Siemens Building Technologies, Inc.