Point Database; Overview - Siemens BACNET 125-699 Owner's Manual

3

Point Database

Overview

This chapter presents a description of the Siemens BACnet Heat Pump Controller—Multi-
Stage point database including point descriptors, point addresses, and a listing of
applications in which each point is found.
Description Address
CTLR ADDRESS 01
APPLICATION 02
RETURN DELAY 03
ROOM TEMP {04}
HEAT.COOL {05}
DAY CLG STPT 06
DAY HTG STPT 07
NGT CLG STPT 08
NGT HTG STPT 09
DMPR MlN POS 10
Siemens Building Technologies, Inc.
Application
2583, 2584, 2590 ldentifies the controller on the FLN trunk.
2583, 2584, 2590 Identification number of the program running in the
controller.
Valid input: 2583, 2584, 2590
2583, 2584 Amount of time the heat pump will remain off after a return
from power failure.
2583, 2584, 2590 Actual reading from the room temperature sensor.
2583, 2584 Current mode of operation for applications that can be either
a heating mode or a cooling mode.
2583, 2584 Temperature setpoint in degrees that the controller
maintains during day periods in cooling mode if a room
temperature sensor setpoint dial is not present or is not
used. See STPT DIAL.
Valid entry range: 48° to 95°F (9°to 35°C)
2583, 2584 Temperature setpoint in degrees that the controller
maintains during day periods in heating mode if a room
temperature sensor setpoint dial is not present or is not
used. See STPT DIAL.
Valid entry range: 48° to 95°F (9° to 35°C)
2583, 2584 Temperature setpoint in degrees that the controller
maintains during night periods in cooling mode.
Valid entry range: 48° to 95°F (9° to 35°C)
2583, 2584 Temperature setpoint in degrees that the controller
maintains during night periods in heating mode.
Valid entry range: 48° to 95°F (9° to 35°C)
2583, 2584 Minimum position the damper will be commanded to during
day mode.
Description
18