Setting Point-To-Multipoint - Gigaset 2060isdn User Manual

I_KAP03.FM5
8.12.98

Setting point-to-multipoint

. t Service
t Local op.
t Multicell op.
t means: browse with u
Gigaset 2060isdn, Inland:
Point to multipoint is the default access mode of your Gi-
gaset 2060isdn. Use the procedure described here to
configure the point-to-multipoint mode and define opera-
tion as local or multicell (in other words mobile units con-
figured for use with one or more base stations).
When configured in this way your Gigaset 2060isdn is
compatible only with a point-to-multipoint access in-
stalled by your network provider. For more information on
multicell operation,
Ž
The comfort mobile unit is idle. You will be prompted to
enter the system code in the course of this procedure
(default code: "0000").
t
Meaning: see footnote
t System settings t Configuration
After confirming - and thus activating - "Point to MP ." , se-
lect:
For operation with one base station (single-cell mode, de-
fault)
or
For operation with more than one base station.
If you select multicell operation:
Enable or disable calls from and to multiple base stations.
It is not advisable to enable calls between inter-
nal users across multiple base stations unless
your Gigaset 2060isdn is connected to a private
branch exchange.
The PBX must support this internal traffic. For
more information on point-to-multipoint opera-
tion
or u
Z
Basic settings
page 81.
t Point to MP .
page 17 and page 84
press x
and
to confirm
OK
NEXT
A30853-X210-B101-1-19
23