Table of Contents
Advertisement
18.7.99
Operating in a telephone system
Possible signalling method settings
. t Service
@33x
u
REDIAL
@37x
u
REDIAL
kap09.fm5
To be able to operate your Gigaset 2011 in a telephone
system, you must first
1.
check the signalling method,
2. enter the analog trunk or MSI
3. enter the pause lengths after the
analog trunk or MSI.
Call number display (CLIP) can only be used if
supported by the telephone system.
The factory default for the signaling method is
DTMF/Flash.
You must first reset this setting to one of the following in
order to operate your handset in telephone systems:
DP
or
DTMF/Flash.
Please also consult the instructions for use supplied with
your telephone system.
( t means: scroll with
Activate the Service menu item.
#1
Start the setting procedure.
Enter the four-digit base code (factory default: "0000")
o
(
page 43).
Set dial pulsing (DP)
SET
or
Dual-tone multifrequency signalling DTMF/Flash
SET
Gigaset 2011 Comfort, GBR: A30852-X1106-B307-1-
Important basic settings
u
Z
, confirm with
x
OK
)
47
Advertisement
Table of Contents
