Siemens Gigaset SL55 Owner's Manual page 7

First Steps
Registering the handset
A Gigaset SL55 handset can be registered
on up to four base stations.
You must initiate handset registration on
the handset and on the base.
After it has registered, the handset returns
to idle status. The internal number of the
handset appears in the display, e.g.
If it does not, repeat the procedure.
On the base station
To find out how to register the handset on
the base station, see the user guide for the
base station.
On the handset
¢ ¢
w Ð
Handset
s
Select base station, e.g.
Base 1, and press
~
Enter the system PIN for the
base station and press
(depending on the base sta-
tion). The following flashes in
the display, e.g.
Placing the handset in the charging
cradle
¤
Plug the charging cradle mains adapter
into a mains power socket.
¤
Place the handset in the charging cra-
dle with the display facing forward.
To charge the battery pack, leave the
handset in the charging cradle.
Notes:
– If the handset has switched itself off
because the battery pack is flat and is then
placed in the charging cradle, it will switch
itself on automatically.
– Only place the handset in the charging cra-
dle that is intended for it.
For questions and problems see page 22.
6
INT 1.
¢
Register H/Set
.
§OK§
§OK§
Base 1.
Initial charging and discharging of the
battery pack
If the handset is activated, the flashing
battery icon e in the top right of the dis-
play indicates that the battery pack is
being charged.
During handset operation, the battery
icon indicates the charge status of the bat-
tery pack (page 1). The correct charge sta-
tus can only be displayed if the battery
pack is first fully charged and discharged.
¤
To do this, leave the handset in the
charging cradle continuously for ten
hours. Your handset need not be
switched on for it to charge.
¤
Afterwards, remove the handset from
the charging cradle and do not put it
back again until the battery pack is fully
discharged.
Note:
After the first battery charge and discharge,
you may replace your handset in the charging
cradle after every call.
Please note:
u
Always repeat the charging and dis-
charging procedure if you remove the
battery pack from the handset and
insert it again.
u
The battery pack may warm up as it is
charging. This is not dangerous.
u
After a time the charge capacity of the
battery pack will decrease for technical
reasons.
¤
Set the date and the time, for example
to ensure the correct time of incoming
calls is recorded.
Setting the date and time
The date and time must be set in order to,
e.g. have the correct time for incoming
calls and be able to use the alarm clock
and calendar.
¤
If you have not yet set the date and
time, press the display key
the input field.
to open
§Time§