Ryobi EMB1800TP Owner's Operating Manual page 6

2. Turn the switch to position "l" (ON). Point the jet of air in
front of you and move forward slowly to gather together
the leaves or to move the leaves from inaccessible areas.
(Fig. 5)
Vacuum mode
1. Set the blower/vac lever anti-clockwise. Make sure that
the dust bag is fitted properly.(Fig. 6)
2. Press the switch to "l" (ON). Position the suction mouth
on the area to be cleared.
3. Hold the machime as shown in Fig 7, tilting the blower/
vac tube slightly, and use a sweeping action to collect
light debris with a few inches distance between the
opening of Blower/Vac tube and the floor or ground to be
clean up. when the dust bag is full, the vacuum power
will be gradually reduced. When this happens, turn the
switch to position "0" (OFF) and disconnect the plug from
the electricity supply. Wait until the suction shredder
wheel has stopped completely before operation. Open
the hinge inside the bag, spread out the opening and
empty it completely. If you have collected only leaves or
vegetable matter, they will already have been shredded
and will be ready for composting. Zip up the bag and
resume work.
WARNING: Before re-fitting the bag, clean the
inside of the outlet opening, removing any
shredded deposits. Pay special attention to
the cleaning of the supporting edges of the
air flow deviator inside of the motor housing.
Fig. 7
Electronic speed control setting
(EMB2200TP only) (Fig 8.)
Fig. 5
Your machine EMB2200TP complete with a speed controller
to allow you adjust the air speed for various working
condition.
Turn the speed controller forward to increase the motor speed
and blowing/vacuum air speed.
Fig. 8
Fig. 6
Patio Head
The patio head is to facilitate vacuum cleaning on the paved
area outdoor especially applicable to the slotted area.
6
5