Attaching The Lens To The Camera - Sony BVP-900 Operation Manual

Attaching the Lens to the Camera

Attach a hanger-mount-type lens recommended by
Sony. For details on the lens, refer to the instruction
manual furnished with the lens.
When you intend to install the following lens,
modification is required on the CCD unit. Refer to
your Sony representative.
Canon J40×9.5B IMS/J40×9.5B ISS
J18×8B IMS/J18×8B ISS
J14×9BIMS/J14×9B ISS
Fujinon A44×9.5 ΒΕSM-18LP
A44×9.5 ΒΕSM-18LPB
A17×8.5 ΒΕSM-18LP
A17×8.5 ΒΕSM-18LPB
Lens
A
1
Loosen the lens-lock knob and turn the lens lock
counterclockwise to the horizontal position.
2
Align the pin on the lens with the U-shaped notch,
then hook the edge of the lens on the projection of
the camera.
3
Couple the lens to the camera.
4
Turn the lens lock clockwise, then fasten the lens-
lock knob.
Pin U-shaped notch
Edge
2
4
1 1
Lens-lock knob
Attaching the lens to the BVP-900/900P
Notes
Be sure to check the following three points before
attaching the lens:
• That the pan-lock and tilt-lock levers on the tripod
are fixed
• That the specified CCD unit is correctly mounted to
the camera
• That there is not a pin at part A on the lens shown in
the figure below (if there is, remove it). If the pin
cannot be removed, consult your Sony representative.
Projection
Lens lock
3
17 (E)