Shindaiwa 89303 Owner's/Operator's Manual page 7

Assembly (continued)
Cutting Attachment Shield - C unit
1. Insert the cutting attachment shield
between the outer tube and the cutting
attachment mounting plate.
NOTE:
It may be necessary to loosen the retain-
ing nut and clamp screw to adjust cutting
attachment shield mounting plate.
2. Fit the two shims and the bracket over
the outer tube and loosely install the
four socket-head screws.
3. Tighten the four socket-head cap
screws to secure the cutting attach-
ment shield.
CAUTION!
Make sure the clamp screw and
retaining nut are securely tightened
before tightening the four socket-
head cap screws.
WARNING!
NEVER operate the unit with-
out the cutting attachment shield
installed and tightly secured!
Sub-Shield
(when trimmer head is in use)
1. Attach the shield extension to the cut-
ting attachment shield.
WARNING!
NEVER use this machine with-
out sub-shield when using a trimmer
head.
CAUTION!
Make sure the sub-shield is completely
hooked at the hook receiver.
Socket-Head
Cap Screws
Shim
Clamp Screw
Mounting Plate
Retaining
Nut
Cutting Attachment Shield
Hook Receiver
Sub-shield
Attach the sub-shield to the cutting attachment
shield for TX units when using a trimmer head
TX unit
Bracket
Shim
Cutting Attachment
Shield w/subshield
Hook
Outer Tube
Line Cutter
7