Sherwood RD-6106 Operation Instructions Manual page 16

Sherwood audio/video receiver operation instructions
Table of Contents

Advertisement

Adjusting the speaker settings
Adjust the settings of front, center ,rear speakers and
subwoofer connected.
If the speaker setting is adjusted to "S", the low range
bass sound of the channel(s) is redirected to the
subwoofer or the front channels and if the speaker
setting is adjusted to "N", the sound of the channel(s)
is redirected to other channels.
Press the SPEAKER MODE button for
2
more than 2 seconds to enter the front-
center-rear speaker mode.
SPEAKER
MODE
The front-center-rear speaker setting is displayed.
When the SPEAKER button is set to off, the 6 CH
DIRECT is selected as an input source or "ANALOG"
is selected as signal input in the stereo mode, the
speaker mode function cannot be available.
Memorize the desired speaker setting
4
while it is displayed.
MEMO/ENTER
The desired speaker setting is memorized and the
receiver enters the subwoofer mode.
If the speaker setting display disappears, start again
from step 2 above.
Memorize the subwoofer setting while it is
6
displayed.
MEMO/ENTER
If the subwoofer setting display disappears, start
again from step 2 above.
Select the desired speaker setting.
3
Each time this button is pressed, one of 11 different
speaker settings is selected and displayed for 8
seconds as follows;
FL--CS--RS, FL--CL--RS, FL--CL--RL,
FL--CL--RN, FL--CS--RL, FL--CN--RL,
FL--CS--RN, FL--CN--RS, FS--CS--RS,
FS--CS--RN and FS--CN--RS
In the displays, F stands for Front, C for Center, R
for Rear, L for Large, S for Small and N for None.
When judging whether a speaker is Large or Small,
please note that a standard large speaker has a cone
size larger than 12 cm(5 inches).
The following speaker settings cannot be selected.
Front :Small, Center : Large and Rear : Large(FS--
CL--RL) or Center : None and Rear : None(CN--
RN) setting.
Select the desired subwoofer setting.
5
Each time this button is pressed, the subwoofer
setting changes and is displayed for 8 seconds as
follows;
SUB W(oofer) -- Y(es): When using a powered
SUB W(oofer) -- N(o) : When not using a
If the front speaker is set to "S", the subwoofer is
automatically set to "Y".
Checking the speaker setting
Each time this button is pressed briefly, the front-
center-rear speaker or subwoofer setting is
displayed.
16
SPEAKER
MODE
SPEAKER
MODE
subwoofer.
powered subwoofer.
SPEAKER
MODE

Advertisement

Table of Contents
loading

Table of Contents