Dubbing From Deck B To Deck A - Sherwood Newcastle D-480 Operating Instructions Manual

RECORDING A CD AUTOMATICALLY
When this unit is connected to a Sherwood DIGI LINK Ⅲ CD player controlled remotely by the DIGI LINK
system, the CD Synchro record function can be operated.
Before starting CD synchro recording, adjust the recording level and the balance.
Repeat steps 1,2,3 and 4 of "RECORDING"
1
Procedure.
Start CD syncro recording.
3
The CD is selected automatically on the amplifier DIGI LINK Ⅲ receiver.
If 8 seconds elapses after starting recording, the CD player starts play automatically.
NOTE
Only when the erase protection taps on the cassette tapes are in place, CD synchro record function will be
operated.
During CD synchro recording, if other program source on the receiver is selected, the unit stops CD
synchro recording and starts recording the selected program source.

DUBBING FROM DECK B to DECK A

Open the cassette door by pressing the
1
EJECT button and load a blank cassette
tape into DECK A and prerecorded
cassette tape into DECK B.
CD SYN REC
B C
HIGH NORM
CD SYN MPX
REC
L
dB -00 -20 -10
R
13
According to the tape length, edit the
2
tracks to be recorded on the CD player
referring to the operating instructions of
that.
M
RELAY P
MIN SEC
REC
-6 -3 0 +3 +6
Select the reverse mode
2
: Recording of a single side.
: Recording of both sides.
REVERSE