DD-6200(G) 2007.3.29 10:23 AM 페이지 2 Introduction R R R R E E E E A A A A D D D D T T T T H H H H I I I I S S S S B B B B E E E E F F F F O O O O R R R R E E E E O O O O P P P P E E E E R R R R A A A A T T T T I I I I N N N N G G G G Y Y Y Y O O O O U U U U R R R R U U U U N N N N I I I I T T T T This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage"...
DD-6200(G) 2007.3.29 10:23 AM 페이지 3 C C C C O O O O N N N N T T T T E E E E N N N N T T T T S S S S Introduction Introduction �READ THIS BEFORE OPERATING YOUR UNIT .
Connect the cords between the PLAY OUTPUT jacks of this unit and the PLAY INPUT jacks of your amplifier. ③ ③ DIGI LINK JACKS Connect this jack to the DIGI LINK jack of Sherwood amplifier/receiver bearing the DIGI LINK III or II logo to control this unit remotely by DIGI LINK system. ④ ④ AC INPUT CORD Plug this cord into the switched AC outlet of amplifier or a wall AC outlet.
DD-6200(G) 2007.3.29 10:23 AM 페이지 5 Front Panel Controls ① ① POWER SWITCH Press this switch to turn the power on and press again to turn the power off. For system operation, plug the AC input cord into the switched AC outlet on amplifier or receiver, keep the POWER switch ON and control power ON/OFF with the power operation on the amplifier or receiver.
Page 7
DD-6200(G) 2007.3.29 10:23 AM 페이지 6 ⑨ ⑨ PAUSE BUTTON( Press this button to temporarily stop playing back or recording. To restart, press the PLAY button. ⑩ ⑩ REVERSE PLAY BUTTON( Press this button to play back the back side of the tape.
Page 8
This unit can be remotely controlled with Sherwood DIGI LINK III amplifier or receiver. �For available functions, refer to the compatible unit’s operating instructions. �To listen to tapes by DIGI LINK system, first make DIGI LINK connection between this unit and Sherwood compatible amplifier or receiver.
DD-6200(G) 2007.3.29 10:23 AM 페이지 8 Before Operation � � NOTES ON CASSETTE TAPE � � CLEANING THE HEAD SECTION �For the best condition of the deck, always keep �Before loading a cassette tape, take up the the head (recording/playback/erase), capstan slack in the tape to prevent it from becoming and pinch roller clean.
DD-6200(G) 2007.3.29 10:23 AM 페이지 9 Operations P P P P L L L L A A A A Y Y Y Y I I I I N N N N G G G G B B B B A A A A C C C C K K K K T T T T A A A A P P P P E E E E S S S S Note : Do not use the metal tapes because these are not played back and recorded correctly.
DD-6200(G) 2007.3.29 10:23 AM 페이지 10 To temporarily stop playback. To stop playback. (Deck A only) �“ ” indicator lights up. �To restart playback, press the corresponding PLAY button. To rapidly advance or rewind the tape, press the corresponding button in the stop mode.
C C C C D D D D S S S S Y Y Y Y N N N N C C C C H H H H R R R R O O O O R R R R E E E E C C C C O O O O R R R R D D D D I I I I N N N N G G G G �When this unit is connected to a Sherwood compatible CD player controlled remotely by the DIGI LINK III system, the CD synchro recording can be performed.
DD-6200(G) 2007.3.29 10:23 AM 페이지 13 D D D D U U U U B B B B B B B B I I I I N N N N G G G G F F F F R R R R O O O O M M M M D D D D E E E E C C C C K K K K B B B B T T T T O O O O D D D D E E E E C C C C K K K K A A A A Open the cassette door by pressing Start dubbing.
DD-6200(G) 2007.3.29 10:23 AM 페이지 14 Selecting the desired deck counter mode Resetting the counter �In each counter mode, you can reset the counter �Select the Deck A or the Deck B counter mode to “0000” or “00 min. 00 sec.”.
DD-6200(G) 2007.3.29 10:23 AM 페이지 15 Troubleshooting Guide If your unit should not perform as expected, consult the table below to see if the problem can be corrected before seeking help from your dealer or our service organization. PROBLEM POSSIBLE CAUSE...