Enhancing Your System; Timer And Sleep Operation - Sharp XL-DH229 Operation Manual

Timer and sleep operation

(Remote control only) (continued)
Sleep operation
The radio, compact disc, iPod and USB can all be turned
off automatically.
1
Play back the desired sound source.
2
Press the SLEEP button.
3
Within 10 seconds, press the SLEEP button repeatedly
to select the time.
10 20
4
"SLEEP" will appear.
5
The unit will enter the power stand-by mode
automatically after the preset time has elapsed. The
volume will be turned down 1 minute before the sleep
operation fi nishes.
To confi rm the remaining sleep time:
1
While "SLEEP" is indicated, press the SLEEP button.
To cancel the sleep operation:
Press the ON/STAND-BY button while "SLEEP" is
indicated. To cancel the sleep operation without setting
the unit to the stand-by mode, proceed as follows.
1
While "SLEEP" is indicated, press the SLEEP button.
2
Within 10 seconds, press the SLEEP button repeatedly
to select "SLEEP 00".
To use timer and sleep operation together
Sleep and timer playback:
For example, you can fall asleep listening to the radio and
wake up to CD in the next morning.
1
Set the sleep time (see above, steps 1 - 5).
2
While the sleep timer is set, set the timer playback
(steps 2 - 9, page 12).
Timer playback setting
Sleep timer setting
90 minutes
Sleep operation will
automatically stop
30 ....... 80 90
End time
Desired time
Timer playback start
time

Enhancing your system

The connection cord is not included. Purchase a commercially
available cord as shown below.
Audio cable
(not supplied)
Listening to the playback sounds of
portable audio player, etc.
1
Use a connection cord to connect the portable audio
player etc. to the AUDIO IN jack. When using video
equipment, connect the audio output to this unit and
the video output to a television.
2
Press the ON/STAND-BY button to turn the power on.
3
Press the AUDIO IN button on the remote control or
FUNCTION button repeatedly on main unit to select
AUDIO IN function.
4
Play the connected equipment. If volume level of the
connected device is too high, sound distortion may
occur. Should this happen, lower the volume of the
connected device. If volume level is too low, increase
the volume of the connected device.
Note:
To prevent noise interference, place the unit away from the
television.
Headphones
Do not turn the volume on to full at switch on and listen
to music at moderate levels. Excessive sound pressure
from earphones and headphones can cause hearing
loss.
Before plugging in or unplugging the headphone,
reduce the volume.
Be sure your headphone has a 1/8" (3.5 mm) diameter
plug and impedance between 16 and 50 ohms. The
recommended impedance is 32 ohms.
Plugging in the headphone disconnects the speakers
automatically. Adjust the volume using the VOLUME
control.
E-13
Portable
audio
player, etc.
M I C RO C O M P O N E N T S Y S T E M
XL-DH229P