Removing And Installing The Lamp Unit - Sharp XV-Z15000 Operation Manual

Removing and Installing the Lamp Unit

• Do not remove the lamp unit from the projector right after use. The lamp and parts
Warning!
around the lamp will be very hot and may cause burns or injury.
Info
• Do not touch the glass surface of the lamp
unit or the inside of the projector.
• To avoid injury to yourself and damage to
the lamp, make sure you carefully follow
the steps below.
• Do not loosen other screws except for the
lamp unit cover and lamp unit.
1
Press STANDBY/ON on the
projector or STANDBY on the
remote control to put the projec-
tor into standby mode.
2
Disconnect the power cord.
• Unplug the power cord from the AC
socket.
• Leave the lamp until it has fully cooled
down (about 1 hour).
3
Remove the lamp unit cover.
• Close the lens shutter. Loosen the user
service screw (1) that secures the lamp
unit cover. Remove the lamp unit cover
(2).
Optional
accessory
STANDBY/ON button STANDBY/ON button
AC socket AC socket
2 2
1 1
User service screw User service screw
(for lamp unit cover) (for lamp unit cover)
Lamp unit
AN-K15LP
-51