Connecting To Component Video Equipment Using A Component Cable (Input 1 Or 2); Connecting To Rgb Video Equipment Using A 5Rca Rgb Cable (Input 1 Or 2) - Sharp XV-Z10000 Operation Manual

Connecting to
Component Video Equipment
Using a Component Cable
(INPUT 1 or 2)
Use a component cable when connecting to the
INPUT 1 or 2 terminal, component video equip-
ment such as DVD players and DTV* decoders.
*DTV is the umbrella term used to describe the
new digital television system in the United States.
Connect the projector to the com-
ponent video equipment using the
component cable.
Note
When connecting the projector to the
video equipment in this way, select "Com-
ponent" for "Signal Type" in the "Options"
menu, or select the Component mode by
pressing on the remote control. See
page 64.
Set the "Resolution" of "Special Modes"
to "480P" during input of a 525P signal.
Connecting to RGB Video
Equipment Using a 5RCA
RGB Cable (INPUT 1 or 2)
Use a 5RCA RGB cable when connecting to
the INPUT 1 or 2 terminal, RGB video equip-
ment such as DVD players and DTV* decod-
ers.
Connect the projector to the RGB
video equipment using the 5RCA
RGB cable.
Note
When connecting the projector to the
video equipment in this way, select "RGB"
for "Signal Type" in the "Options" menu,
or select the RGB mode by pressing
on the remote control. See page 64.
The (HD/C sync) and (VD) terminals may
be used depending on the specifications
of the DTV decoder connected to this pro-
jector. Please refer to the operation
manual of the DTV decoder for details.
-18
Component cable
(commercially available)
The component jack for a DVD and so forth may be indi-
cated with Y, C or C . Connect each jack in the manner
B R
shown below at this time.
Y
Projector
DVD player or
DTV decoder
Y
5RCA RGB cable
(Commercially available)
To analog component
output terminal
DVD player or
DTV* decoder
P P
B R
C C
B R
To analog RGB
output terminal
DVD player or
DTV* decoder