Maintaining Your Vacuum; Emptying The Dust Cup; Cleaning The Filters - Shark Rocket HV384Q Series Instructions Manual

MAINTAINING YOUR VACUUM

WARNING: Hand
wash filters with
water only to prevent
damage from
cleaning chemicals�
Allow ALL filters
to dry completely
before replacing
in the vacuum to
prevent liquid from
being drawn into
electric parts�
CAUTION: Turn power
off and unplug before
servicing�
IMPORTANT: Clean the
dust screen inside the dust
cup as required.
NOTE: Empty dust cup
when debris reaches the
MAX fill line.
RECOMMENDED
FILTER CLEANING
SCHEDULE:
Pre-Motor Filter Kit

EMPTYING THE DUST CUP

(Foam & Felt)
1 Press the Wand Release button on the top of the wand to
XPMFK320
disconnect the handheld vacuum from the wand.
Clean once a month.
Post-Motor Filter
To remove the dust cup from the handheld vacuum,
XPSTFH380
squeeze the two Dust Cup Release buttons on both sides
Clean once a year.
of the base at the same time, then pull out the dust cup.
17
1-800-798-7398
Empty
OR
Dust Cup
Release
Empty
2
Hold dust cup over a trash bin and press
the Empty button on the front of the dust
cup. The bottom lid will open, allowing the
debris to fall out.
3
Once dust cup is empty, close the bottom
lid and insert dust cup back into handheld
vacuum until you hear it click into place.
Pre-Motor filters
Clean Filter
Post-Motor filter

CLEANING THE FILTERS

1 Access the Pre-Motor foam and felt
filters by lifting the latch on the top of the
handheld vacuum. Remove and rinse
the filters with water. Tap loose dirt off
filters between washes as needed. Once
completely dry, insert the felt filter first,
then place the foam filter on top of it.
2
Access the Post-Motor filter under the
handle. Remove and rinse the filter
with water.
s h a r kc l e a n . c o m
Foam
Felt
18