Regarding the Lamp (Continued)
Removing and Installing the
Lamp Unit
Warning!
•
Do not remove the lamp unit from the
projector right after use. The lamp and parts
around the lamp will be very hot and may
cause burns or injury.
Info
•
Do not touch the glass surface of the lamp
unit or the inside of the projector.
•
To avoid injury to yourself and damage to the
lamp, make sure you carefully follow the
steps below.
•
Do not loosen other screws except for the
lamp unit cover and lamp unit.
1
1
Press STANDBY/ON on the
projector or STANDBY on the
remote control to put the
projector into standby mode.
2
2
Disconnect the power cord.
•
Unplug the power cord from the AC
socket.
•
Leave the lamp until it has fully cooled
down (about 1 hour).
3
3
Remove the lamp unit cover.
•
Close the lens shutter. Loosen the user
service screw (1) that secures the lamp
unit cover. Remove the lamp unit cover
(2).
56
Optional
Optional
accessory
accessory
STANDBY/ON button
STANDBY/ON button
AC socket
AC socket
2
2
1
1
User service screw
User service screw
(for lamp unit cover)
(for lamp unit cover)
Lamp unit
Lamp unit
AN-D400LP
AN-D400LP