Advertisement
Install Front Logs
4. Remove small burner log from packaging. This log
has two holes on the bottom. These holes correspond
to two log pins located on the burner top. Place the
small burner log on the two log pins. See Figure 6.
When properly placed, this log will rest on both the
burner and ember tray/Teco-Sil.
Figure 6. Burner Log Installed
5. Remove top left log from packaging. Place upper
portion of the log into the indentation on the rear left
log.
The bottom right tip of the log will rest on the
ember tray and the Teco-Sil rock. See Figure 7 and
Figure 8.
INDENTATION-LEFT LOG
Figure 7. Location of Left Log indentation
Heat & Glo • LOGS-350X, LOGS-SL5 Installation Instructions • 2279-935 • 12/17
INDENTATIONS-RIGHT LOG
Figure 8. Location of Right Log Indentation
6. Remove top right log from packaging. There are
indentations located in the right rear log and small
burner log to locate the log. Place log into indenta-
tions as shown in Figure 8 and Figure 9.
Figure 9. Top Right Log Installed - Log Set Complete
INDENTATION
3
Advertisement
