Rolled Edging; 3-Thread Rolled Edge - Baby Lock Acclaim BLES4 Instruction And Reference Manual

Rolled Edging

The rolled edge setting is used to achieve the narrowest stitch possible (1.5mm) on your Baby Lock
serger. The stitch is suitable for seaming sheer and lightweight fabrics and for edging and hemming
lightweight fabrics.

3-Thread Rolled Edge

With the stitch selector set on "D", a narrow hem will become a rolled edge. The fabric edge rolls
around the stitch finger. The upper looper wraps the fabric edge while the lower looper thread is
nearly invisible on the back side of the stitch formation.
Remove the left needle and thread. Clear the stitch fingers. Turn the stitch length adjusting dial
counterclockwise into the rolled hem range at 0.75-4.0R setting. (fig. A) Set the stitch width dial to
3.5 "M". (fig. B)
For a 3-thread rolled edge, move the stitch selector lever to "D" and follow the suggested settings
and threading diagram below.
Note: These settings may vary depending on thread type and fabric.
NEEDLES
right
A
LENGTH
WIDTH
0.75-4.0R
3.5
L
R
B
STITCH WAVE/OVERLOCK
SELECTOR
SELECTOR
OVERLOCK
D
R
O
L
L
E
D
E
D
G
I
N
G
30