How To Use Revolutionair Needle Threader - Baby Lock Acclaim BLES4 Instruction And Reference Manual

How to Use RevolutionAir Needle Threader

1. Open the front cover and the blade cover.
2. Set the threading lever from serging position to
threading position. (fig.A)
3. Rotate the machine handwheel slowly toward you
until it is in the locked position. (fig. B)
4. Press the needle threading lever down. (fig. C)
5. Make sure the needle threading inlet is completely
A
set up just behind the needles. (fig. D)
6. Press the "Push to thread needles button" to
activate the threading pump while holding the thread
end directly in front of the needle eye.
The thread will be pulled through the needle eye.
(fig. E)
If threading pump shuts off before threading is
completed, press the button again.
7. Your selected needle threading mode will determine
the threading pump's operation. (see page 22)
B
8. Lift the needle threading lever up. (fig. F)
9. Carefully remove the thread from the inlet.
10. Set the threading lever to serging position.
11. Close the blade cover and the front cover.
C
L R
D
Push to
thread needles
button
L R
E
F