Yamaha JT1 Series Service Manual page 84

JTl
1
MOTORCYCLE
SERVICE NEWS
YAMAHA INTERNATIONAL CORPORATION
MONTEBELLO, CALIFORNIA
DATE 1/18/71
LIGHTING KIT (Continued)
2. Install light.
NUMBER
261
PAGE
2 of 4
3. Route wiring through fender brace hole and under seat.
G. Brake light switch
1.
Bolt stay to upper rear engine mount, right hand side.
2. Insert switch rod in brake lever hole.
3. Adjust as necessary.
H. Connections
1. Main harness, taillight leads, and source wires terminate
under seat.
2. Use nylon clip to secure to righthand frame tube next to
(and over) oil tank (do not allow wires to touch muffler).
3. Caution: See sketches as otherwise shorts may occur.
4. Hook up according to schematic, page 4.
5. Re-install seat, tank, etc.
6. Check output per voltage curve, Page 3.
- 78 -