Tone-Out Multi-Channel Monitoring; Location-Based (Gps) Scanning - Uniden Trunk Tracker IV BCD996T User Manual

Set Tone — Sets the audio tone frequency for the page. Then choose the Tone setting.
•
Edit Tone A — Set the audio frequency for Tone A
•
Edit Tone B — Set the audio frequency for Tone B
Notes:
For two-tone pages, enter a value for A and B.
For one-tone pages using short tones of less than 3.75 seconds, enter the tone value for A, and 0 (zero) for B.
For long-tone pages, such as group pages of more than 3.75 seconds, enter 0 (zero) for A and the tone value for B.
Set Delay Time — Sets the time the scanner remains in monitor mode after the scanner receives a page and the carrier drops.
•
1-5 sec — the scanner resumes standby mode after the carrier drops and the selected time expires.
•
Infinite — you must press [HOLD/RESUME] after a page to resume standby mode.
•
Off — the scanner resumes standby as soon as the carrier drops after a page.
Set Alert — Sets the alert the scanner uses when it receives an alert.
Alert 1 - 9 — scroll to select the alert tone pattern, The scanner sounds each alert as you scroll to its numbered value
Off — the scanner does not sound an alert.
After you select an alert pattern, the scanner prompts for the alert level for a received alert. Level options 1 to 15 sets a fixed audio
level independent of the main volume setting. AUTO uses the main volume setting for the alerts.

Tone-Out Multi-Channel Monitoring

The scanner can check multiple tone combination pages for channels whose settings are the same. To achieve this, set the channel
to the same frequency, modulation, and attenuation. For example, the scanner checks tone combinations for channel 1 to channel 3
for the following settings
Ch 1
Ch 2
Ch 3
Ch 4
Ch 5
Ch 6
Although set to Auto, if the band default is anything other than FM or NFM, modulation will always be FM.
If you switch to Tone-Out Standby Mode for Multi-Channel Monitoring, the display switches every 2 seconds to show the frequency it
is checking. However, it is, at the same time, checking all frequencies for Tones. If one is detected, it switches to Tone-Out Hold
mode.

Location-Based (GPS) Scanning

The BCD996T can make use of data transmitted from an attached GPS unit that lets the radio automatically enable and disable
systems based on the geographic information you provide such as:
•
Latitude (the center of the range)
•
Longitude (center of the range)
•
Range (the radius of a circle around the latitude and longitude coordinates selected from .5, 1, 3, 5, 10, 20, 30,and 50 miles.
Frequency (MHz) Modulation
137.0000 Auto (NFM)
137.0000 Auto (NFM)
137.0000 Auto (NFM)
137.0000 NFM
137.0000 FM
138.0000 Auto (NFM)
Attenuator Tone A (Hz)
Off 1000.0
Off 2200.0
Off 1500.0
Off 1800.0
Off 2000.0
Off 1000.0
61
Tone B (Hz)
2000.0
3200.0
2500.0
2800.0
3000.0
2000.0